Install Your New Cisco IP Phone 7800 Series Multiplatform Phone in webex
In addition to powering up and connecting to the network, your phone comes with all the pieces you need to set it up on your desk.
The phone registers with the server after it connects to the network, and then the startup process begins.
A new firmware load is installed on the phone once it is connected to the network.
As far as the footstand of Cisco IP Phone 7811 is concerned, you cannot adjust it.
An installation guide for Cisco IP Phone 7800 Series can provide a visual overview of these steps.
- There are two ends to the handset cable, which you need to connect to a phone and the other end to a handset. Plug the long, straight end into the phone.
- Your network cable should be connected to the network port on the phone via the network cable from your network.
- Ensure that the footstand is attached and that the phone is angled appropriately.
-
The lower slots should be filled in with curved connectors.
-
The connectors in the upper slot of the footstand must be snapped into place once you lift the footstand.
In order to connect or disconnect the footstand properly, you may need to exert a greater amount of force than you think is necessary.
-
Make sure that the phone is positioned at a comfortable angle.
- Ensure that the external power source is plugged in.
- Monitor the process of the phone starting up. A proper configuration of the phone can be verified by this step.
- Upgrade the phone’s firmware to the most recent version by allowing the phone to upgrade.
- Call the phone to check that it works as it should and that all the features are working properly before you use it.